Premier Mounts Projector Accessories PDS 023 User Manual

PDS-023 Projector Bracket

PDS-023 Projector Bracket Installation Instructions

M4 x 10mm Phillips

Head Screws

(Qty 3)

PDS-023 Bracket

(Qty 1)

M4 x 10mm

Security Head

Screws (Qty 3)

Premier Mounts

3130 E. Miraloma Ave.

Anaheim, CA 92806

Phone: (800) 368-9700 Fax: (800) 832-4888

1. Using a screwdriver, secure the PDS-023 mounting bracket using three (3)

M4 x 10mm Phillips Head screws. Do not over tighten these screws.

Overtightening the screws may result in damaging the threaded inserts on

the projector.

NOTE: Please refer to the PDS Base Box Installation Instructions to attach

the PDS Base Box to the PDS-023 mounting bracket.

1. Invert the projector and place it on a soft and flat surface. Remove any foot

levelers that might possibly prevent the correct installation of the bracket.

2. Locate the three mounting points located on the bottom of the projector.

3. Line up the mounting points on the projector with the mounting holes on

the PDS-023 mounting bracket.

NOTE: The projector (shown above) is for illustration purposes only.

Installation Instructions

Page 1

IN-PDS023.R0